Search This Supplers Products:HMI, PLC and Industrial PCHuman Machine InterfaceIndustrial AutomationIndustrial Panel PCProgrammable Logic Controller
time2017/09/06
The device is applied to the fixed position punch and the fixed length shear. It can be used to cut the strip of ribbon, ribbon, elastic band, nylon belt, etc. By using the ultrasonic cutting and drilling, the cutting edge will be neat and smooth, also with better drilling effect.
There are two modes for selection: drilling mode and cutting mode. The drilling mode will drill according to the setting length and cut after drilling. A belt can punch 20 holes at most. The cutting mode only has cutting function. Input section includes start / pause button, material detection, jog button. The output section has a feed stepper motor, punch, cutter cylinder, ultrasonic cutter.
Process:
After the start of automatic operation, it will cut at first. Then by determining the distance between the cutter and punch which is smaller, to determine the action in the next time will be cutting or drilling.
Electrical configuration:
PlC: LX3V-0806MT
HMI: LEVI700LK
1.Operating screen(Monitor the status of the device and set the machine operating parameters)
2.System parameters (mechanical run time setting and mechanical parameter setting)
Plc program:
The action of the machine is not complex, the key is the processing of pulses, and the location of the cutter and hole is accurate. Also the interface of wecon hmi is user friendly, and the wecon plc is easy to learn, meanwhile with the powerful function.
网络文化经营许可证:浙网文[2013]0268-027号|增值电信业务经营许可证:浙B2-20080224-1 2007-2024 Tradevv.com. All rights reserved.